FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 2 of 2

Thread: My Favorite DeLorean Web Sites Part II of II.

  1. #1
    Senior Member
    Join Date:  May 2011

    Location:  Renton, WA

    Posts:    342

    My VIN:    02261

    Club(s):   (PNDC)

    My Favorite DeLorean Web Sites Part II of II.

    Link to Part I of II.
    http://dmctalk.org/showthread.php?19...s-Part-I-of-II.

    Bumper and Trim Black 3400 - a BLACK liquid for any interior/exterior BLACK vinyl, BLACK rubber, BLACK plastic so long as it’s BLACK. Okay.
    http://www.urethanesupply.com/

    Bondo, Restore Black, 800, 8 fluid ounces. For any interior/exterior BLACK parts.
    http://www.3M.com

    BLACK Paint for exterior
    First roughen surface with Scotch Brite pad or 400 grit sand paper.
    SEM 38353 Plastic/Leather Prep. To clean plastic before painting.
    SEM 38363 Sand Free. Clear spray adhesion promoter. Apply first coat of paint while Sand Free is still wet.
    SEM 39143 Trim Black. For black side moldings, side view mirrors, side skirts, black plastic air filter box, black plastic ignition coil cover.
    SEM 39103 Bumper Coater. For black area on front and rear fascia.

    BIG RED Premium Nonmelt Multi-Purpose Grease, for your Speedometer Right Hand Angle Drive and Ball Joints. 14.5 oz tube.
    http://www.questchemicalcorp.com/pdfs/L103tech.pdf

    Devcon, 5 minute Epoxy Gel. Good solvent resistance to gas, oil and other solvents.
    http://www.devcon.com/products/produ...m?familyid=176

    Bighead Bonding Fasteners. Male threaded stud 38mm x 15mm Rectangle. M6 x 16mm.
    Product code M1/T38-M6x16. Available in Mild Steel or 316 Stainless Steel.
    These studs are bonded inside the front and rear fascias during manufacturing.
    http://www.bighead.co.uk/

    Permatex the Right Stuff® Gasket Maker. Heavy-bodied, black, elastomeric rubber provides instant seal. Superior flexibility and adhesion accommodates joint movement. Excellent oil and transmission fluid resistance. Eliminate costly inventory of cut gaskets
    http://www.devcon.com/products/produ...2&familyid=370

    Car Covers
    Outside Use - Custom Fit for DeLorean, Weathershield HP, Gray, Size G3, Number CB26PG
    Outside Use - Custom Fit for DeLorean, Noah Fabric, Gray, Size G3, Number CB26NH
    http://www.covercraft.com/
    http://www.calcarcover.com/
    https://www.bigskycarcovers.com/

    Starter Heat Shield Wrap and Snap Strap Stainless Steel straps for securing the insulating wrap
    http://www.thermotec.com/

    Fuel Cooler
    http://www.flex-a-lite.com/auto/html...ct-cooler.html
    http://www.perma-cool.com/Catalog/Cat_page15.html
    http://www.dana.com/automotive_solutions/

    CRL 3M Fast Tack Trim Adhesive 3M8031 - for Clear Plastic Sheathing inside door panels Permits Repositioning and is good for securing Vinyl and Headliner fabric
    http://www.technologylk.com/product_...roduct_ID=2742

    3M Super Weatherstrip Adhesive Black 08008 - for Outer Door Seals and also for SS Letters on Rear Bumper
    http://www.amazon.com/3M-Super-Weath.../dp/B000J52Y9Q

    Glue
    http://www.lightningbondglue.com/

    Indiglo Dash Kit
    http://www.az-d.org/indiglo.html

    Leather Care and Vinyl Care - Tell Them You Belong to a DeLorean Car Club, when ordering!
    http://www.leatherique.com/

    Spark Plug pictures
    http://www.dansmc.com/Spark_Plugs/Sp...s_catalog.html

    Sound Deadening - for interior to be attached to Glass Reinforced Plastic (GRP) body
    eDead 120 is 115-120 mils thick and has self adhesive on one side and aluminum foil on the other with Bytul Rubber in between. It is sold by the square foot so you can buy as little or as much as you need. One square foot weighs approximately 16oz or one pound.
    http://www.edesignaudio.com/

    Vibration Dampers, Noise Barriers, Rattles & Squeaks
    http://www.secondskinaudio.com/

    Other noise insulating manufacturers.
    http://www.soundcoat.com/
    http://www.emtechinc.net/insulation.htm

    Stainless Finishers, Wolfhead
    Wolfhead Wheel 2" Wide, 12 brush with 3/8" mandrel. Order 1/4" wide cut Aluminum Oxide abrasive strip loads with 60 Grit.
    http://www.gandpmachinery.com/html/pages/brchrs.htm

    Blending pads for Stainless Steel exterior. Scotch-Brite 7446 Grey by 3M. Grit Grade :Medium.

    Stainless Steel DeLorean Frame
    http://www.pearce-design.com/

    Stainless Steel Fasteners
    http://www.totallystainless.com/totally.html

    Batteries, DeLoreans need Size 34/78
    http://www.sears.com/
    http://www.exide.com/

    Electrical Connectors
    http://www.eagleday.com/
    http://www.britishwiring.com/

    Self Fusing Tape - Used in motor vehicles to wrap wire bundles
    http://order.waytekwire.com

    Ceramic Anti-Seize Lubricant. Good for extreme high temperatures up to 1400 C or 2500 F.
    Product name, Rock’n Roll
    http://www.jwalterinc.com/walter_us/servlet/Home

    Tire Size Calculator
    http://www.miata.net/garage/tirecalc.html

    Classic Car Insurance
    http://www.hagerty.com/
    http://www.amig.com/
    http://www.americancollectors.com/
    http://www.heacockclassic.com/
    http://www.grundy.com/
    http://www.jctaylor.com/
    http://www.nationwide.com/
    http://www.chubb.com/
    http://www.classic-british-cars.com/...insurance.html
    http://www.vehicleappraisers.com/Ins...Questions.html

    Air Conditioning System Parts and HELP
    http://www.idqusa.com/
    http://www.vintageair.com/
    http://www.aircondition.com/
    http://www.ackits.com/
    http://www.acsource.com/
    http://www.sanden.com/
    http://www.autofrost.com/hotshot/index.html
    http://www.id-usa.com/how_to_faqs_retrofitting.asp#5
    Mark Vanyo
    Links to DeLorean related web sites!
    http://dmctalk.org/showthread.php?19...s-Part-I-of-II.

  2. #2
    Vin3299's Doc DeLorean03's Avatar
    Join Date:  May 2011

    Location:  Eglin AFB, FL

    Posts:    1,603

    My VIN:    3299

    Good man for reposting this link. I remember you posted this RIGHT before the old site went down. Good man
    DMCTalk.org Moderator

    Actual snippet of a conversation from Sept 2013:

    Me: Eddie, I can't wait to get the car back when you're done with it.

    Eddie: Yeah, you'll be able to give the car gas, and it won't be - like - embarrassing....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •