So here is a problem I have had for some time now. When the engine is COLD the engine idles at 775 RPMs. Then when it gets HOT it idles at 1,500 RPMs. So where do I start testing to see what is bad now?
Location: Las Vegas, NV
Posts: 128
My VIN: Jan '82 #11153
So here is a problem I have had for some time now. When the engine is COLD the engine idles at 775 RPMs. Then when it gets HOT it idles at 1,500 RPMs. So where do I start testing to see what is bad now?
Check if you're idle speed motor is stuck.
Look at your deceleration valve springs. If the springs are not evenly spaced, you have the bad ones most likely.
Dave M vin 03572
http://dm-eng.weebly.com/
Location: Las Vegas, NV
Posts: 128
My VIN: Jan '82 #11153
Well first off, I have no idea where they are located to even check them, dummy me. Second, in trying to find them on the internet, etc., I read that they do nothing fir an automatic transmission. Mine is an automatic. Maybe should have said that in the beginning. Is this correct or should I still be checking?
Location: Las Vegas, NV
Posts: 128
My VIN: Jan '82 #11153
The car starts at the low 775 RPM and runs kind of rough. Then when it hits a higher temperature, it runs at 1,000 - 1,200 RPM and real smooth. Both times when cold and hot I disconnected the electrical plug from the idle speed motor - no change whatsoever in the RPM. I'm guessing that means it has issues? Checking here because it is such a pain to get out. The microswitch is set to connect when at no foot pedle.
Dave M vin 03572
http://dm-eng.weebly.com/
I would first start with basics (especially if this happened recently), before looking at springs in the throttle body which rarely go bad. check to see if the idle circuit is working, or at least energizing. Secondly, check your vacuum lines, especially at ISM, valve cover back where the distributor advance solenoid is and make sure the plug is on.
As far as the idle circuit goes, make sure the microswitch is engaging and check for continuity. Deceleration springs and ISM's can go bad, but it's not common and probably not the cause here. I would suspect a bad idle computer before any of that.
Last edited by Michael; 01-21-2024 at 03:23 PM.
I had a similar problem once, after doing a valley rebuild. Turned out the throttle linkage was just not set up quite right. It would do this reliably if I started the engine cold and touched NOTHING... after a few minutes the idle would very slowly start to come up and stick around 1,000 or higher can't remember exactly where but I have a thread on here. I had to disconnect all the linkage and start from square one with all the adjustments. That fixed it.
Andy Lien
VIN 11596 Jan 1982 build - owned since Nov. 2000!
Total frame-off restoration completed 2021-2023
Photography and Backpacking is life.
Was Fargo, ND
Now Kansas City
^^^
same. I think Andy actually helped me when I had this problem. I changed throttle spool springs and cleaned up cable. It was sticking. then adjusted the cable on the spool to get the right tension.
My engine would start out with a normal RPM and once warmed up it would idle high. It didn't idle rough when first started though. The problem was my idle speed motor. Before it started, could moisture have gotten into the engine? You can take it off and look inside, if the rotating door in the ISM moves smoothly then the problem is probably not the ISM. If it is the problem you can get a replacement on amazon for around $40.