Today's work:
Installed wide band oxygen sensor
Installed relay board
Installed ECU + MAP sensor vacuum line
Tomorrow's work:
Run power and ground to relay board
Connect all wires to relay board
Load a 'good' base tune to ECU
Calibrate TPS
Calibrate ground switch for vacuum solenoid + idle speed motor
Try to get car to run
I do not have the microswitch installed, but I am doing what Jim Reeve does - I am tapping the FIdle output of the relay board into the ground wire for the vacuum advance solenoid + idle speed motor. I have the ECU set so that it will provide ground when the throttle position sensor is below a certain point.