Page 3 of 3 FirstFirst 1 2 3
Results 21 to 23 of 23

Thread: DMOCO Shift Gate

  1. #21
    My friends think I'm nuts jawn101's Avatar
    Join Date:  May 2011

    Location:  Sacramento-ish

    Posts:    4,265

    My VIN:    02100

    Club(s):   (NCDMC) (DCUK)

    Quote Originally Posted by Jimmyvonviggle View Post
    Be good if we could use something like shrink tubing for electrical wires. If there was one wide enough we could slip over the stick then shrink.
    I have some that is thick enough to go over the shifter, so it definitely exists. It came in a multi-pack of different sizes that I got at Radio Shack, I think.
    Jon
    1981 DMC-12 #02100. July 1981. 5-speed, black, grooved w/flap.
    restoration log, April 2012 to present
    restoration log, March 2011 to April 2012
    full and detailed photo restoration log

  2. #22
    Senior Member GS450-Junkie's Avatar
    Join Date:  May 2011

    Location:  Midwest

    Posts:    594

    Quote Originally Posted by DPI JOSH View Post
    We have a version coming out but it is VERY different. The one you are taking about caused an issue of the shifter being metal on metal with the gate piece. We have an insert that extends slightly past the shift gate edge so that when you move the shifter it runs against the plastic instead of the shift gate. These will be released in January after a bit of testing. I will have the first prototypes from stainless works in December.
    Josh, did your SS shifter gate ever get completed??

  3. #23
    President, DeLorean Industries
    Join Date:  May 2011

    Location:  CLE/PHX

    Posts:    2,255

    My VIN:    5646,5080, 5880, 10234, 3639, 2518, 10586, 1538

    Upper plate yes but I have yet to machine the custom bottom section. On the short list of projects to close out.

Page 3 of 3 FirstFirst 1 2 3

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •