What have you done to your DeLorean today?

[Christian Dietrich]

Nice.

Thank you

Sent from my SM-N920P using Tapatalk

[Domi]

Really cool stereo system

[opethmike]

I lava fiber wrapped the mid-length headers for my engine swap project.

[Christian Dietrich]

Really cool stereo system

Thank you Domi!

Sent from my SM-N920P using Tapatalk

[mr_maxime]

A new radio would be a bittersweet gift for me. Such a PITA job to do lol. I really don't want to mess with it again.

[opethmike]

A new radio would be a bittersweet gift for me. Such a PITA job to do lol. I really don't want to mess with it again.

Second time around should be much easier if it is the same DIN size, I think? Might just need a different wiring harness adapter.

[bytes311]

I swapped the old o-ring under the FD with a brand new one and now my car hunts like crazy open-looped. The o-ring must not be seated properly to create a tight seal.

[Bitsyncmaster]

I swapped the old o-ring under the FD with a brand new one and now my car hunts like crazy open-looped. The o-ring must not be seated properly to create a tight seal.

Make sure your connector on the vacuum advance solenoid is connected. Hard to see how that O-ring would cause hunting unless it hits the plunger.

[bytes311]

All I did was disconnect the center fuel line from the FD, tilt the bottom towards me, put the new o-ring on, and then screwed the FD back into place. I'll double check the vacuum advance. Thanks Dave.

[Christian Dietrich]

Second time around should be much easier if it is the same DIN size, I think? Might just need a different wiring harness adapter.

What made it nice and easy with my car was the fact that I replaced it with a Alpine and coming from already having an Alpine I was able to reuse the sleeve and the main pin connector and all I had to do was run a new wire for the Bluetooth radio and XM satellite antenna.

Sent from my SM-N920P using Tapatalk