What have you done to your DeLorean today?

[Jonathan]

Took the car out for a drive last night. Beautiful time to be driving here as the temperatures are just perfect for cruising. I'd seen a Starsky & Hutch car a couple of times earlier this summer, but only met him recently (on a day I didn't have my car with me). We both ended up pulling into the same gas station last night. Must have looked pretty funny seeing a couple "star cars" there. Sort of like COSplay for cars... like CARplay. Is that a word? It is now.

Starsky and Hutch.jpg

[Chris 16409]

I pretty much ran out of things to do to my car last year. I did finally put my badges on last week so that's something. I like them, understated but noticeable.

Attachment 53101

Michael, where did you find those badges?

[Domi]

Michael, where did you find those badges?

If you allow me, take a look here:
http://www.ebay.com/itm/281589712301

[Christian Dietrich]

I pretty much ran out of things to do to my car last year. I did finally put my badges on last week so that's something. I like them, understated but noticeable.

Attachment 53101

Actually i like how they look. Yeah they stand out but they do it well!

Sent from my SM-N920P using Tapatalk

[JAS037]

The standard NC plate begins with 3 letters and then four numbers. You cannot request a personalized plate beginning with 3 letters, followed by numbers.

I did not think of that... interesting. Thanks!

[Nuclearbacon]

Today I FINALLY replaced my non existent steering wheel bushing!!!!

Now that I've done it, I could probably do the whole job in about an hour, but whew!

Here you can see my old and new bushing:



I know what you're saying. That bushing is FINE! It just didn't seem to work. hmm.

And here you can see how deep I had to go...



at this point I was saying... "Can I put this back together??"



It got back together

This was from my AWESOME Stainless Steel brake booster bracket installation



I've been busy

[Lwanmtr]

Replacing my bushing took me a couple days...the joints were so stuck together it took a while for the sauce to get in and loosen them up..putting it all back together went easy..though despite my best effort, the wheel is not centered..lol

[SS Spoiler]

Be sure the pinch bolt at the end of the steering
column u-joint goes through the groove at the end.....

[Christian Dietrich]

Got the fascia put back on today after installing aluminum bars and straighten out the eyebrowling . Not to bad i have to say! Tbis winter i will remove them and repaint everything.

Sent from my SM-N920P using Tapatalk

[Michael]

Got the fascia put back on today after installing aluminum bars and straighten out the eyebrowling . Not to bad i have to say! Tbis winter i will remove them and repaint everything.

Sent from my SM-N920P using Tapatalk

Like a razor! I did mine several years ago and they never reverted back