Page 2 of 2 FirstFirst 1 2
Results 11 to 12 of 12

Thread: door roof seal 106967

  1. #11
    EFI'd dn010's Avatar
    Join Date:  Jul 2011

    Location:  Florida: Pinellas County

    Posts:    1,787

    My VIN:    5003

    Club(s):   (DCF)

    I didn't know you were supposed to remove the panel to replace these...

    I replaced mine many years ago and used stainless sheet screws as well. Removing the rivets out leaves a of it portion inside the roof which will rattle around until it finds a spot to rest. I opted to drill the rivets out, I was confident I wouldn't go beyond it and damage the stainless. If you're worried about the bar, you can remove the gas strut and prop the door further open to make it easier/better angle to get to the rivets.
    -----Dan B.

  2. #12
    Delorean Guru
    Join Date:  May 2011

    Location:  Northern NJ

    Posts:    7,114

    My VIN:    10757

    Club(s):   (DMA)

    Another tip, place a piece of copper tubing over the drill bit leaving just the tip of the drill exposed to act as a stop so you don't touch the door skin. Try to drill the rivet out at an angle removing just the head of the rivet.
    David Teitelbaum

Page 2 of 2 FirstFirst 1 2

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts