Official Thread for Billet Pulleys for A/C Idler

[1batt4u]

I just need a couple more to reach 10

[Ron]

If you are missing a post-

"8. Members: STOP posting remarks like "free bump,good guy or good item”. If you are NOT going to purchase the items listed. Remarks like "you can get it cheaper at so and so place" are NOT allowed.
Again, do not post a question or remark if you do not intend to buy the item."

[LEVY]

I'm in!

I just need a couple more to reach 10

[1batt4u]

If you're planning to place the order in the next month, I'm in. I need to replace one of the bearings anyway, "might as well" go for the upgrade.

I take it your in??

1. Accipiter
2. Jimmyvonviggle
3. John U
4. DMC5180
5. RIUM

[1batt4u]

1. Accipiter
2. Jimmyvonviggle
3. John U
4. DMC5180
5. RIUM
6. LEVY

Thanx!! Ok keep em coming!!

[DMC5180]

Make sure you don't get powder coating in the bearing bore and snap ring grooves. Frankly, clear anodizing would be a better choice but The clear powder coat should be fine. It will be interesting to how fast it wears off the V groove.

[1batt4u]

I almost forgot about this! I never check the for sale section!

[1batt4u]

Make sure you don't get powder coating in the bearing bore and snap ring grooves. Frankly, clear anodizing would be a better choice but The clear powder coat should be fine. It will be interesting to how fast it wears off the V groove.

Yes I know, bearing bores and snap ring sections will be covered!

I actually started getting these made!!! I can't wait for people will slow me down!

[Fluxat88MPH]

I'm in keep me posted!

[1batt4u]

I'm in keep me posted!

1. Accipiter
2. Jimmyvonviggle
3. John U
4. DMC5180
5. RIUM
6. LEVY
7. Fluxat88MPH

Thank you!!!