Location: atlanta, ga, usa, earth, sol, milky way
Posts: 1,088
My VIN: 2072
Club(s): (SEDOC) (DCUK)
If there is interest, My Inventor Club is willing to host a Tech Session.
It's a new commercial tech shop / maker space in downtown atlanta, of which I am a member.
There's plenty of parking, and it's close enough that I could even drag 2930 over!
Of course, this is assuming no one steps up to host...... So, someone step up!
I'd host at my place but I only have half a driveway.......
--buddy
Location: GA
Posts: 774
My VIN: 5302
Club(s): (SEDOC) (DCUK)
Did you have a falling out with Freeside? Or is the new club just "better/nicer," hence the switch?
Derek L
VIN 5302
Location: atlanta, ga, usa, earth, sol, milky way
Posts: 1,088
My VIN: 2072
Club(s): (SEDOC) (DCUK)
I'm still a member of both for now, but the new club is much nicer......Originally Posted by DL4567
www.myinventorclub.com
--buddy
Location: GA
Posts: 774
My VIN: 5302
Club(s): (SEDOC) (DCUK)
That does look nice. Impressive equipment list there.
Derek L
VIN 5302
Posts: 237
My VIN: 10110
Club(s): (SEDOC) (DCUK)
Any interest in having a SEDOC session at my place in Evans Ga, sometime in May-June?
There's a large parking lot located here:
526 North Belair Road
Evans, GA 30809
This is walking distance from my house.
The Food Lion that was there shut down, and I've contacted the owner about the possibility of hosting an event.
I know it is a little out of the way for some Georgia members, but it would be closer than Atlanta for South Carolina members.
Location: LaFayette, Ga/Chattanooga, Tn
Posts: 126
My VIN: 6410
I do like the area and the parking lot, however its too far for me personally to be able to make it. Especially if I got my D running that would be too far of a maiden voyage.
David
DeLoDave, 6410
Posting Permissions
Reply With Quote