FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
LS Swapper
Parking brake pivot pin measurments
Well I was not very careful when dissembling my brakes and chucked the rear park brake lever pivot pin. My parts are off for powdercoating so I cannnot easily measure the part. Just wondering the hole diameter and the length of the pin (thickness of lever). Hopefully someone has their caliper out or even wheel off and can do a quick measurement.
I will take the measurements and source a pin. Since this part does not exist I will post up my findings for future reference!
Thanks in advance!
-
http://store.delorean.com/c-299-6-2-...ing-brake.aspx
Are you talking about part# 37 or #41? I have my brakes apart right now and I can get some measurements for you when I get home.
-
LS Swapper
Thanks for the response! I am actually referring to #25. If you could take a few minutes to measure the pin itself I would be very appreciative!
-
pivot pin.JPGbrakes.jpg
Here are the measurements I got off of that pin for you. If you can't find anything similar you could always try to see if the pin of the Jaguar brakes will work. $4.86 here:
http://www.sngbarratt.com/ProductDet...1-54b11384c881
-
LS Swapper
Originally Posted by
JMLaux
WOW! Thank you so much!
Very detailed drawing, even have the specs on the chamfer. Could take that down to a machine shop if I turn up nothing haha.
As for cross referencing I will check out the link. Tried to find the Jag pin on Rock Auto but it was not there.
Once again, thank you very much. I will report my findings back to this thread to help people in the future.
-
LS Swapper
Found this on McMaster Carr. 316 Stainless. A little longer at 1.5", but the 1.25" pin is too short in terms of usable length.
http://www.mcmaster.com/#92401a637/=nl1hil
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules