Can anyone provide the measurements of the lower control arm's mounting point? See the attached image for the 3 lengths that I need. All measurements from inside the shock tower. Any questions, let me know and TIA
Posts: 159
Can anyone provide the measurements of the lower control arm's mounting point? See the attached image for the 3 lengths that I need. All measurements from inside the shock tower. Any questions, let me know and TIA
Location: Illinois
Posts: 2,440
My VIN: 11408
Club(s): (DMWC) (TXDMC) (DCUK) (DOI)
I would get you these measurements but my frame is at the galvanizer. If you do not have the measurements in a week or so I can help you out.
Supercharged 5.3L LS4 + Porsche 6spd
[email protected]
lsdelorean.com
I am not affiliated with Delorean Midwest in anyway.
Posts: 159
That would be great, thanks.
Location: Northern NJ
Posts: 8,582
My VIN: 10757 1st place Concourse 1998
Many measurements of the frame are in the Workshop Manual, last page. Mostly to check if it is bent.
David Teitelbaum
Posts: 159
Posts: 159
Can anyone help?
I don't have my car apart or I'd measure for you. I just picked up s set of the DMCH Eibach springs and ill try and measure for you when I install them.
Yeah, it's dirty. I drive it.
Location: sacramento
Posts: 1,415
My VIN: 1768
Club(s): (NCDMC) (DCUK)
For measurement #2 I get 2 1/16"
Posts: 159
Location: Illinois
Posts: 2,440
My VIN: 11408
Club(s): (DMWC) (TXDMC) (DCUK) (DOI)
Supercharged 5.3L LS4 + Porsche 6spd
[email protected]
lsdelorean.com
I am not affiliated with Delorean Midwest in anyway.