My melted Fan Fail Relay

[DMC5180]

I just finished up 10 fan fails but waiting on a lable maker to mark the revision. That lable maker should arrive next week.

Revision? What's different about it vs previous units?

STEVEN,

If you don't get Dave's Fan Fail unit, you WILL need to pull up the front of relays and check the Wire from the melted terminal for heat damage and discoloration. It would not be uncommon to have too replace a foot of the wire from the terminal. The heat damaged wire ,if not replaced, will likely cause further problems due to high resistance. You will want to make sure you splice into bright shinny copper when you do the splice ( soldering is best) or a solder sleeve (heat shrink) splice connector.