Posts: 705
My VIN: 6654
Club(s): (DCF)
I just noticed that the bolt beside the drivers seat back adjustment is loose. I tried to tighten it and think something may be stripped. has anyone had problems with it.
Do you have an angle drive I can buy from you and install?
Also my 15 year old granddaughter says she wants to come over also.
See you Saturday.
Thanks,
Lenny
DMCH New Build in 2005, Stage II, DPI Stainless Exhaust, Eibach Suspension, 170 Mph Speedometer, Xenon Lights, Wings-A-Loft, DMC Wide Angle Side Mirrors, 3rd Brake Light
Location: Seattle, WA
Posts: 127
My VIN: 5096
If it is the same bolt that was loose on mine, it is a nut on the other side and needs a wrench on it. Anyone that wants to come is fine by me.
Posts: 705
My VIN: 6654
Club(s): (DCF)
Do you have an angle drive? my speedometer died
Thanks,
Lenny
DMCH New Build in 2005, Stage II, DPI Stainless Exhaust, Eibach Suspension, 170 Mph Speedometer, Xenon Lights, Wings-A-Loft, DMC Wide Angle Side Mirrors, 3rd Brake Light
Location: Seattle, WA
Posts: 127
My VIN: 5096
Ed doesn't tend to keep any stock so I doubt he does. I don't as I replaced mine a number of years ago. If you get one ordered and shipped it should be here before the weekend and we could install it though. Just a note, it is possible that the angle drive is good and just slipping which is an easy fix, it is also possible that the speedo cable itself went bad, although that usually results in a bouncing needle vs a completely non working needle.
Last edited by Lightning; 07-26-2014 at 11:27 PM.
Location: Melbourne, FL
Posts: 310
Club(s): (DCF)
You can call and of the vendors and just have them ship it to me.Originally Posted by Lenny
SEOmotorsports.com
www.facebook.com/seomotorsports
Location: Melbourne, FL
Posts: 310
Club(s): (DCF)
If anyone has any dietary restriction please let me know. We're trying to figure out what we're going to eat.
-Ed
SEOmotorsports.com
www.facebook.com/seomotorsports
Location: Orlando, Florida
Posts: 2,734
My VIN: 01643
Club(s): (DCF) (DCO) (DCUK)
So I did a test fit and I can indeed fit the new side skirts from the ground effects kit in the car. I haven't painted them because everyone has told me that you inevitably knick them up doing all the modification for installation. I'm planning to bring them in the hopes of getting the existing rocker panels off and drilling the new ones (but not doing final installation.)
Ed any issue with this? I've heard the old bolts can be pretty terrible to try to get out on the rocker panels. Usually require either drilling or cutting to remove them. Any tools you want me to bring? Drill? Angle grinder? Pneumatic cutoff tools?
Location: Melbourne, FL
Posts: 310
Club(s): (DCF)
I have just about anything you'll need for cutting or grinding.
SEOmotorsports.com
www.facebook.com/seomotorsports
Location: Orlando, Florida
Posts: 2,734
My VIN: 01643
Club(s): (DCF) (DCO) (DCUK)
Sounds good, I'll bring the skirts.
Location: Orlando, Florida
Posts: 2,734
My VIN: 01643
Club(s): (DCF) (DCO) (DCUK)
Ok so just to clarify:
Tomorrow 10:00am
500 North Drive Suite 8
Melbourne, FL. 32934
See everyone there!
Posting Permissions
Reply With Quote
