FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Senior Member
Originally Posted by
Jason
What do you mean? Material cost? I probably used between $10 and $20 worth of plastic and fabric, but a good bit of that was because it took me a few tries to get things right.
That's amazing! Was this your own printer or a third party?
-
Originally Posted by
Drive Stainless
That's amazing! Was this your own printer or a third party?
It's a LulzBot TAZ 5 that I have at home.
-
I 3D printed some custom ductwork so that I could route the center A/C vents to the sides of the center console to make room for a 2 din head unit while still retaining correct control of the center vents via the mode switch. This did require cutting down the raised sections on the heater box where the rubber boot for the center vents attach to on 5mm high.
newvents.JPG
IMG_20180920_110940320.jpg
IMG_20181015_234007074.jpg
-
Originally Posted by
Jason
I 3D printed some custom ductwork so that I could route the center A/C vents to the sides of the center console to make room for a 2 din head unit while still retaining correct control of the center vents via the mode switch. This did require cutting down the raised sections on the heater box where the rubber boot for the center vents attach to on 5mm high.
newvents.JPG
IMG_20180920_110940320.jpg
IMG_20181015_234007074.jpg
Very nice!
Wish I could've done this, but I completed my double din setup before 3d printers got cheap...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules