Spring SEDOC Tech & Social Days - Saturdays May 24 and 31, 2014 - Buford, GA

[David_NYS]

Of course! The 24th or 31st?

I'll be down the 31st. Might need an angle drive replaced, if anyone has experience in that arena.

[ccurzio]

I'll be down the 31st. Might need an angle drive replaced, if anyone has experience in that arena.

I have plenty. I'll bring the tools.

[nullset]

I'm trying to debate whether to come down tomorrow, the 31st, or both.

How's it looking so far?

Things I could do, if there's time:
- replace coolant hoses (i have a new set. may replace all or replace as required)
- install self bleeder kit
- install new angle driver
- pressure test coolant system
- still figure out what the hell is wrong with my idle / mixture / etc

--buddy

[David_NYS]

I have plenty. I'll bring the tools.

Great! Thank you! I have no experience in this area!

[Bikercmbc]

I have brought my big breaker bar and can replace angle drives in 15min, except I didn't bring the 24/27mm socket. Maybe Derek has some 1/2in size sockets and an impact gun.

[RammJaeger]

Anybody have a tool for putting in RivNuts?

[DL4567]

I'm trying to debate whether to come down tomorrow, the 31st, or both.

How's it looking so far?

--buddy

As far as I can tell from what people have written on here, I'm expecting 4-5+ tomorrow, and 6+ on the 31st. And of course, there are always a couple more that come who aren't active on the forum.

I have brought my big breaker bar and can replace angle drives in 15min, except I didn't bring the 24/27mm socket. Maybe Derek has some 1/2in size sockets and an impact gun.

I have done my angle drive twice, so I should have the correct size socket. Not sure about the pipe though.... I remember sliding a 5ft aluminum pipe over my wrench, but that was at the shop in Norcross.

Anybody have a tool for putting in RivNuts?

I have a small hand rivet gun, which may or may not have the right size head for the job. Do you have the rivets?

[Bikercmbc]

ok, my breaker bar should take the place of that pipe. ill be able to figure some how to replace the angle drives with the resources we have.

** rivnut tools are little different than a rivet tools, same concept except the rivnut tool has a treaded end the rivnut goes on to.

Rammerjammer: ebay has rivnut tools for about $40 and free shipping, just an fyi.

[ccurzio]

I have all of the tools necessary to replace an angle drive. I've done it myself at home twice. I will bring all of it.

[RammJaeger]

ok, my breaker bar should take the place of that pipe. ill be able to figure some how to replace the angle drives with the resources we have.

** rivnut tools are little different than a rivet tools, same concept except the rivnut tool has a treaded end the rivnut goes on to.

Rammerjammer: ebay has rivnut tools for about $40 and free shipping, just an fyi.

Yeah, I don't think I can get a rivnut tool delivered by tomorrow though I was hoping to do it while were were they as I don't know anything about installing rivnuts.