who needs a kit when you can DIY for less than $20. I will put up a pic plus schematics when it's done.
who needs a kit when you can DIY for less than $20. I will put up a pic plus schematics when it's done.
Location: 38.09080 N 23.8005 E
Posts: 2,038
My VIN: MMMMMCMXCII
VIN 5992/Body 5697/Frame 6000/Grey/Manual/ALL LED/Square HALOs/SPAX/DMOCO SS shifter/Genuine MOMO steering/iPhone base/Porsche turbo 997 exhaust/K&N/ SS: f.fascia mounts, brake lines, clutch line+fuel line+tank cover+heat shields/Posi-quiet brake pads/Poly: steering rack inserts+f.sway bar bushing+radius bushing/wings-a-loft/Radius enforced tabs n bolts/turbo fans... Oh! + a BTTF on/off replica set etc (still adding)
Location: San Antonio
Posts: 266
My VIN: 5628
Still waiting on those schematics....I have my kit ready to install
Here ya go. No guarantees though. I'll be making a few pics of the installation in the back later on. But it'll take some time before I can do that.
Notes:
- "To windows" is not connected"
- the blue "to thermistor" goes to one side of the thermistor, while
- the brown "12v" goes to the other side and inline fuse is NOT pictured in this diagram.
- the purple wire splits in 2 (with a diode on each wire), but I actually only use one of them and cut the other one off.
- note that the brown "12v continuous" on the 9 pin connector is NOT protected by the thermistor. So only the remote system RED should be on there (with the fuse). The others go through the thermistor (which roughly speaking is a fuse).
Last edited by robvanderveer; 07-03-2014 at 02:45 AM. Reason: wire details added
Thanks for all the info on your setup.!
I have a question that i hope can be answered on this thread. I'm very good with my engine but electronic systems are new stuff to me.
I own a car with a keyless remote system with door poppers, i guess thats a wings-a-loft- setup.
Original heavy solenoids still in there, and original door lock module.
The doors started to click and lock and unlock themselves plus i suspect drain the battery. I unplugged the system and have been manual.
From what i read on this thread it seems really inexpensive with your setup to get nice actuators to replace the solenoids. What about the module?
Could i do this with my system and avoid the 250 dollar dmc digital door module?
A list of what i need would be very helpful.
should i toss out my setup and get this stuff or can i use some of what i have?
1. Universal Car Remote Control Central Door Lock Locking Keyless Entry System
2. DC 12V Auto Car 8 Wires Black Plastic Shell Central Door Lock Actuator (would this replace the door lock module? save 250$ from buying the dmc one?)
As you can see from this photo brow. This is my door i already have the actuators to pop the door open.
Thanks for the help.
[IMG][/IMG]
Location: San Antonio
Posts: 266
My VIN: 5628
Sweet! I was going to give this a Try this weekend but strepthroat had other plans for me....