This is a test phase. But I don't think it will fail soon.
Positive is that its a very simple task without any drilling or big modifications.
I host the actuator just under the power window's rear mounting position.
(seen upside down)
I place the actuator in that well and fasten it with tire wraps going through the two give holes in the door. Care full not to catch the exterior door handle wire along with it.
I also added a sheet of rubber for a better fastening result.
Finally I added the actuator's wire to fasten it with the front lock's wire. Its right across it
With a simple remote door lock module and controls you can have your own fascinating remote door opening effect!