Wiper Arm Hose Clip - part# 108035

[foreman]

Hi. Obviously I'm here looking for this part. Texas says it's out of stock. I contacted DMC MidWest and they couldn't find one for me either. I'm hoping someone here has one that they are willing to part with. I only ask that it not be broken.

Thanks

--Joe

[Ryan King]

Hi. Obviously I'm here looking for this part. Texas says it's out of stock. I contacted DMC MidWest and they couldn't find one for me either. I'm hoping someone here has one that they are willing to part with. I only ask that it not be broken.

Thanks

--Joe

Joe - I *might* have one. I'll try and check for you today.

[foreman]

Joe - I *might* have one. I'll try and check for you today.

great. thank you for looking :)

[mluder]

He, Joe.

I used a piece of heat shrink tubing. Stretch it over the wiper arm. Feed the washer fluid hose through (make sure you leave enough slack for the arm to move). I aligned the hose with the thin edge of the arm not the flat face. Then use a heat gun to shrink it down. Be careful you don't bubble any paint or make it too tight that it restricts fluid flow. I did mine 3 years ago and it's still going strong and looks fine.

I can send you pics later tonight if you want.

[foreman]

i'm curious to see your fix, but if i could get the actual part, i'd rather go that route. :)

[Ryan King]

I do have one! Pm me your price.

[foreman]

PM sent

[foreman]

Ryan had one. thank you everyone for the help!

on to the next part that my eyes won't be able to look past.