Log in

View Full Version : Tool for Cleaning Bullet Connectors?



lazabby
02-04-2015, 05:12 PM
Is there a tool for cleaning the bullet connectors in the bulkhead? I'm envisioning a tool on a short stick that has both a male at one end and female at the other end with abrasive material that can clean the bullet connectors. If one hasn't been invented, would someone be interested in creating it and including me in on the invention and profits?

Dangermouse
02-04-2015, 06:43 PM
I was looking a Dremel bits last week to see if they had anything, but nothing seemed suitable.

Best I have found is a fiberglass pen, with multiple strands of fiberglass at the tip, for light cleaning and a basic round metal file for heavier corrosion.

http://i.ebayimg.com/00/s/NTAwWDUwMA==/z/ZQUAAMXQyY1TP5Vy/$_12.JPG?set_id=880000500F


http://www.ebay.com/itm/like/191126624992?lpid=82&chn=ps

Bitsyncmaster
02-04-2015, 06:43 PM
I've not seen a tool for that. The female pins would probably spread and not hold a good connection. I have just dunked the connector into TARNX and then clean with solvent. I replace the pin if it is real bad.

Rich
02-04-2015, 09:53 PM
Am with Dave on this. No specific tool I know of for that.

A. Just disconnecting and reconnecting the plug a few times is a good start toward cleaning. Especially if your car is missing the cover in that corner of the engine bay.
B. Recommend you try electrical contact cleaner plus Q-Tips or a clean cloth. Use this or an equivalent: LINK: radioshack-spray-contact-cleaner (http://www.radioshack.com/deoxit-d5s-6-spray-contact-cleaner-and-rejuvenator/6400249.html)

andyd
02-05-2015, 05:05 PM
Discussed here on eurotec
http://www.deloreaneurotec.co.uk/forum/viewtopic.php?f=25&t=4491&hilit=cleaning+connectors

Spittybug
02-05-2015, 05:40 PM
I've used a cylindrical bit in the dremmel with great success. For the males, a thin ribbon of sandpaper.....