PDA

View Full Version : For Sale Lots of parts for sale



Spittybug
03-07-2015, 06:17 PM
Springtime cleanout of garage..... EFI has been operational for a couple of years now and there is definitely no going back, so the parts I haven't already sold are on the block along with some other stuff.

My objective is for these to go to good homes and be put to use. All prices are without shipping. With few exceptions the parts would fit into one of the USPS flat rate boxes for domestic purchases, (S, M or L)

More pictures available upon request. I have set my prices at ~1/3 of DMCH; not unreasonable. For unavailable items, I have assigned a price. If you plan on asking for a lower price, I'm more receptive to bundle deals. :o Please PM me, don't ask in threads. As items sell, I will post such, so no need to ask if something is still available. All parts worked fine when removed but have been sitting for a couple of years.


There are too many photos to attach to thread, so here is a link to my Public folder on Dropbox: https://www.dropbox.com/sh/oa61k4mfqo0kzw0/AADdmuEdZtrbI8wTlgMTP90ca?dl=0

Visors - dirty but should clean up. No vinyl damage. $25 ea
Engine air inlet duct $10
Exhaust manifold stove $10
Air inlet valve $42
License plate bezel (only blemish is a filled hole in top - could be made to disappear with a little patience...) $50
CIS injectors (Injectors were NOT cleaned but engine was running well before EFI conversion) $25 each (with new copper washers)
Injector hoses (all still soft and pliable) $15 ea
Line control pressure hose $15
Line primary pressure hose $18
Vacuum delay valve $24
Lambda ECU (silver) $52
02 sensors (both worked when removed - went to wide band for EFI) $10 ea
Heat shield bracket (below cat) $10
Idle speed ECU $115
Idle/low speed regulator $75
Horns $6 ea
Diagnostic plug and bracket $12
Ignition module ECU $70
Coil $15
Ballast resistor and whole firewall assembly $30
RPM relay $16
Cover stay $22
Sway bar clamp pair $10
Steering wheel - leather in decent shape (replaced with Momo knockoff) $150
Steering wheel - no leather but nice textured plastic, no center $75
Bundles of wire/connectors $20
Craig Radio - unknown if works $75

I haven't dug them out yet, but I also have the original manifold, air cleaner assembly, W pipes, throttle body and other stuff if anyone is interested. Offers accepted.
Help me get rid of this stuff and clean out the garage!!
Thanks.

Silverbullet
03-07-2015, 07:03 PM
Ill take the steering wheel, Horns, and ballast.


Craig... PM'd

Alegria
03-07-2015, 07:40 PM
PM'd...

Spittybug
03-07-2015, 10:15 PM
Assuming all that have agreed to purchase complete their Paypal transactions, the following are now SOLD:

Both steering wheels
Both visors
Ballast and bracket
Craig radio
Both horns

Should something change, I will repost.

Thanks.

Spittybug
03-08-2015, 01:43 PM
I couldn't find strike out in the format options...... red italicized text means the item is spoken for pending Paypal receipt. Any changes to status will be posted. Thanks for all the interest. I guess the prices were right!

Visors - dirty but should clean up. No vinyl damage. $25 ea
Engine air inlet duct $10
Exhaust manifold stove $10
Air inlet valve $42
License plate bezel (only blemish is a filled hole in top - could be made to disappear with a little patience...) $50
CIS injectors (Injectors were NOT cleaned but engine was running well before EFI conversion) $25 each (with new copper washers)
Injector hoses (all still soft and pliable) $15 ea
Line control pressure hose $15
Line primary pressure hose $18
Vacuum delay valve $24
Lambda ECU (silver) $52
02 sensors (both worked when removed - went to wide band for EFI) $10 ea
Heat shield bracket (below cat) $10
Idle speed ECU $115
Idle/low speed regulator $75
Horns $6 ea
Diagnostic plug and bracket $12
Ignition module ECU $70
Coil $15
Ballast resistor and whole firewall assembly $30
RPM relay $16
Cover stay $22
Sway bar clamp pair $10
Steering wheel - leather in decent shape (replaced with Momo knockoff) $150
Steering wheel - no leather but nice textured plastic, no center $75
Bundles of wire/connectors $20
Craig Radio - unknown if works $75

mluder
03-09-2015, 01:48 AM
PM sent on

Lambda ECU (silver) $52
Idle speed ECU $115
Idle/low speed regulator $75

Cheers
Steve

Spittybug
03-09-2015, 04:52 PM
Here is a list of what remains. All offers were followed up with payment, so if you were "on deck", sorry.

Engine air inlet duct $10
Exhaust manifold stove $10
Air inlet valve $42
License plate bezel (only blemish is a filled hole in top - could be made to disappear with a little patience...) $50 I'm surprised no one has hopped on this, I thought they were getting harder to find.....
CIS injectors (Injectors were NOT cleaned but engine was running well before EFI conversion) $25 each (with new copper washers)
Injector hoses (all still soft and pliable) $15 ea
Vacuum delay valve $24
Lambda ECU (silver) $52
02 sensors (both worked when removed - went to wide band for EFI) $10 ea
Heat shield bracket (below cat) $10
Ignition module ECU $70
Cover stay $22
Sway bar clamp pair $10
Bundles of wire/connectors $20

Spittybug
03-14-2015, 11:19 AM
Here is a list of what remains. All offers were followed up with payment, so if you were "on deck", sorry.

Engine air inlet duct $10
Air inlet valve $42
CIS injectors (Injectors were NOT cleaned but engine was running well before EFI conversion) $25 each (with new copper washers)
Injector hoses (all still soft and pliable) $15 ea
Vacuum delay valve $24
02 sensors (both worked when removed - went to wide band for EFI) $10 ea
Heat shield bracket (below cat) $10
Ignition module ECU $7
Sway bar clamp pair $10
Bundles of wire/connectors $20

Spittybug
03-17-2015, 06:35 PM
Ignition module ECU $70 sorry, typo on previous post.