Lower speedometer cable

[Aleksander]

Had the car out for a test run yesterday. On my way home the speedometer needle started bouncing allover and I heard a splintered wire/cable noise.

I pulled out the lower speedometer cable today and it looks a bit beat up at the lower end. What do you guys think?

(I also tested the cable with a drill and the speedometer reading was steady and no bad noise.)

Lower end
http://images.tapatalk-cdn.com/15/05/01/872448cba1bc239a51ae229bcf131364.jpg

Upper and lower end
http://images.tapatalk-cdn.com/15/05/01/cfe8e6d4b0556466b1fd5cf01bbbf1c4.jpg

Lower end
http://images.tapatalk-cdn.com/15/05/01/11a3d77a2046d28b5b18a1fb75e5563e.jpg

Lower end
http://images.tapatalk-cdn.com/15/05/01/b93da47529ebbfa1672b8b8fecb0101e.jpg

Lower end
http://images.tapatalk-cdn.com/15/05/01/4c69d7ee108cced65a57d242e3760df7.jpg

[davidc89]

I was able to replace the inner part of the cable with a universal one from Napa.

[djdogbone]

Your angle drive is seizing up.

[Aleksander]

Okay, that means I have do what?
(Sorry if that's a stupid question, still learning :) )

[Shep]

Okay, that means I have do what?
(Sorry if that's a stupid question, still learning :) )Replace it. Pretty much every vendor carries their own version, with varying degrees of reliability.

One word of caution: gear ratio matters, so if you get a "special t auto" one, your speed (and also mileage) will be low by about 12%. The other features it has are nice, but unless you're okay with intentionally misrepresenting your car's mileage, I'd avoid it.

[Aleksander]

I guess I will encounter issues like that with the vendors in Norway as well.
I'm going to a shop called Norwegian speedometer service tomorrow, hopefully they have good knowledge since they only do speedometer work :-p

But just to add another stupid question, if I only change the lower speedometer cable, it will fail again?

[Shep]

I guess I will encounter issues like that with the vendors in Norway as well.
I'm going to a shop called Norwegian speedometer service tomorrow, hopefully they have good knowledge since they only do speedometer work :-p

But just to add another stupid question, if I only change the lower speedometer cable, it will fail again?Your drill test confirms it's the angle drive, which (unfortunately) is DeLorean-specific. The cable will probably need to be repaired or replaced once you've done so. Any repairs this shop may attempt to the cable won't prevent it from breaking again.

On the other hand, you'll probably have better luck finding the help (and parts) you need on the EuroTec forums. Here's a link:
http://www.deloreaneurotec.uk/viewforum.php?f=59

[Aleksander]

Got new wire today. Pulled the angle drive out as well. It turns smoothly and easy, no sign on it seizing up.
So will change the cable for now and see how it goes.
Thanks for the help :)