cold start trouble

[John U]

My car has been sitting for about 3 weeks. I went to start it today and a few times it started on the prime, then died. Eventually when I got it going it ran rough until it warmed a little.
I have replaced all fuel lines, fuel pump, all sensors, vac lines, etc when I did the VOD. I did not have this problem before doing the VOD work.
The tank is sitting below 1/4

any ideas?

thanks
John

[Bitsyncmaster]

My car has been sitting for about 3 weeks. I went to start it today and a few times it started on the prime, then died. Eventually when I got it going it ran rough until it warmed a little.
I have replaced all fuel lines, fuel pump, all sensors, vac lines, etc when I did the VOD. I did not have this problem before doing the VOD work.
The tank is sitting below 1/4

any ideas?

thanks
John

Was it running good after the VOD work and before you let it sit for 3 weeks.

[John U]

yes it ran well...I think I found the problem....looks like one of the wires that runs into the cold start valve connector was pushed out...I will let the car sit overnight and see how it starts.

John

[John U]

3 good cold starts in two days....looks like problem is solved hopefully