View Full Version : Heat & A/C Blower motor
DMC 2692
12-29-2015, 09:46 PM
My heat/AC blower motor doesn't run on position 3 only. It works fine on 1 2 and 4 though. Is this a switch issue or something else?
Sent from my SAMSUNG-SGH-I337 using Tapatalk
DrJeff
12-29-2015, 10:26 PM
Could be the resistor http://store.delorean.com/p-7593-resistor.aspx, but not sure if you'd just lose speed 3.
DMCMW Dave
12-29-2015, 10:55 PM
Could be the resistor http://store.delorean.com/p-7593-resistor.aspx, but not sure if you'd just lose speed 3.
If the resistor fails you lose speed 1, OR speed 1 AND 2, or speed 1 AND 2 AND 3. Never just 2 or 3.
More likely the relay or the speed switch. Do you hear the relay click when you go from 2 to 3?
jamesvnz
12-30-2015, 03:49 PM
My heat/AC blower motor doesn't run on position 3 only. It works fine on 1 2 and 4 though. Is this a switch issue or something else?
Sent from my SAMSUNG-SGH-I337 using Tapatalk
same!!! i could do with that number 3
David T
12-31-2015, 01:34 PM
same!!! i could do with that number 3
Could be something as simple as the wire for speed 3 fell off of the mode switch. Swap the relays for speeds 3 and 4 making sure none of the wire connectors have backed out of position in the relay block.
jamesvnz
12-31-2015, 06:58 PM
Could be something as simple as the wire for speed 3 fell off of the mode switch. Swap the relays for speeds 3 and 4 making sure none of the wire connectors have backed out of position in the relay block.
thanks Dave I will have a look at this today, :-) i changed the relay and that didn't do a thing.
hopefully i can sort it
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.