smcguiga
05-14-2016, 07:13 PM
Ok, so I recently replaced my door lights with the LED kit from DMC. I also replaced my dome lights with LEDs and in the process the front dome light broke so I ordered one from ebay and it fits great but has slightly different wiring. I can't seem to figure out why the light will only come on when switched or else it seems to stay on all the time. Any ideas which wires go where? How I have it now (with the purple/white disconnected) has it working only when I rock it back and forth to switch it on.
41988
After doing all this I plugged in my buzzer and door lights just to make sure all was working after installing the LEDs and then immediately unplugged all wires from all three door switches and unplugged the buzzer. Now my "door open dash light" comes on and stays on while driving down the road. Once, it turned off after about 5 minutes and then turned back on again a few minutes later. What in the world happened here? I normally leave my doors open in the garage so the door lights will most likely stay unplugged unless I go with Dave's new relay (likely will soon) but I can't figure out what I did to make that door open light come on and stay on!?
--Steven
41988
After doing all this I plugged in my buzzer and door lights just to make sure all was working after installing the LEDs and then immediately unplugged all wires from all three door switches and unplugged the buzzer. Now my "door open dash light" comes on and stays on while driving down the road. Once, it turned off after about 5 minutes and then turned back on again a few minutes later. What in the world happened here? I normally leave my doors open in the garage so the door lights will most likely stay unplugged unless I go with Dave's new relay (likely will soon) but I can't figure out what I did to make that door open light come on and stay on!?
--Steven