View Full Version : Rad cap gurgle and drips
sdg3205
07-03-2016, 02:08 PM
I think it might be time for a new rad cap. After a nice evening drive last night i could hear some faint gurgling from my expansion tank purge hose. Sure enough there were a few drips. No over heating of course, it was actually below 70 last night and my fans didn't even need to come on as it was nice country driving.
Anyone have a brand they recommend?
Jonathan
07-03-2016, 02:21 PM
No recommendations on cap brand, other than to get the Houston one.
Did want to suggest though getting it replaced sooner than later. If the system can't get up to pressure (up to the limit of 14.7 psi), the coolant will potentially boil at a lower temperature. The higher the pressure the higher the temperature allowed while keeping the coolant in liquid form. Same logic as to why a hot coolant system will flash to steam immediately upon opening it up to atmosphere. Zero pressure equals lower boiling point and if that is less than the temperature it already is, you get steam.
For comparison, the primary heat transport system in a CANDU nuclear reactor gets to over 300 degrees Celsius because the pressure is maintained at somewhere north of 1,200 psi. Don't be opening up that bad boy unexpectedly!!
sdg3205
07-03-2016, 02:32 PM
I'm actually planning a quick trip down to Toby's for a proper alignment. I'll see about picking one up while I'm down there.
David T
07-03-2016, 11:33 PM
The cap can be tested. If you overfilled the header tank it is not unexpected you might get a few drips out the overflow hose.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.