View Full Version : Piece of gasket lost in engine
mr_maxime
07-09-2016, 10:07 AM
Im changing the valve cover gasket on my Honda accord and while scraping off the gasket a piece fell down this hole. Is there anyway of removing it without taking the engine apart? Or can I just leave it there?
44281
DMCMW Dave
07-09-2016, 10:47 AM
Im changing the valve cover gasket on my Honda accord and while scraping off the gasket a piece fell down this hole. Is there anyway of removing it without taking the engine apart? Or can I just leave it there?
44281
It will either end up in the oil pan or the filter. If it's a paper gasket I wouldn't worry about it. If it were metal (like a head gasket) it would be a much bigger deal.
You could drain the oil and then try to wash it down with more oil, but it might take a few gallons to flush it all the way out.
mr_maxime
07-09-2016, 11:01 AM
It was a small piece of rubber gasket. I thought it might just go to the oil pan and eventually get caught in the filter but I wanted to make sure. I'd remove the oil pan and take it out if I didn't already know how much of a pain it is.
David T
07-09-2016, 03:02 PM
It was a small piece of rubber gasket. I thought it might just go to the oil pan and eventually get caught in the filter but I wanted to make sure. I'd remove the oil pan and take it out if I didn't already know how much of a pain it is.
Typically you stuff some rags into where the oil drains are on the cylinder head to prevent any dirt or gasket materiel from getting deeper into the motor. A small amount won't hurt and will either stay in the pan or get into the filter. A piece of rubber won't hurt anything. Not worth taking the motor further apart.
mr_maxime
07-09-2016, 03:23 PM
Thanks for the info. Now I'm just stuck out taking out the damn spark plug grommets. YouTube is a lie this can't be done in an hour on a real car lol
DMC-81
07-09-2016, 05:54 PM
Based on the picture, can you grab it with a pick like this?
44312
mr_maxime
07-09-2016, 08:57 PM
No. It went down another hole after that one. The flash lit up the hole and the shadow (above it in this orientation) is another hole. I got everything scraped out and finally replaced the valve cover. Now its on to the radiator replacement...
Ive had bigger chunks of gaskets enter an engine. It goes on a wonderful journey and usually ends up in the pan or filter like Dave said. I would not worry about it.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.