PDA

View Full Version : General Speedometer Reset Shaft Repair



spikeygg
08-11-2016, 10:37 PM
So I'm trying to repair my reset shaft on the speedometer and I just got the point where I'm supposed to remove the three clips from the back of the speedometer face. Any tips on how to remove those bad boys without breaking the plastic studs that they are pushed onto? They seem to be dug into the plastic and I worry about breaking them. Not sure what the best approach is for this.

DMCMW Dave
08-11-2016, 10:57 PM
So I'm trying to repair my reset shaft on the speedometer and I just got the point where I'm supposed to remove the three clips from the back of the speedometer face. Any tips on how to remove those bad boys without breaking the plastic studs that they are pushed onto? They seem to be dug into the plastic and I worry about breaking them. Not sure what the best approach is for this.

There are two small tabs on the clips, in parallel, that face up from the plate. Squeeze them together with a needle-nose pliers and the clips will slide right off.

spikeygg
08-11-2016, 11:06 PM
There are two small tabs on the clips, in parallel, that face up from the plate. Squeeze them together with a needle-nose pliers and the clips will slide right off.

ok, cool. I got the clips off but the face is still stuck to the mechanism. How do I separate them? Do the rubber bushing things come off the faceplate?

spikeygg
08-12-2016, 12:14 AM
Okay, I got this thing apart and put the new shaft into place. However, the instructions say to test the reset function after installing the new shaft before reassembling the entire thing. When I hold the mechanism in my hand and push in the reset button all my tripometer goes to all 4s... what the heck does this mean?? How do I make it reset to 0s?

burch
08-12-2016, 01:03 AM
Okay, I got this thing apart and put the new shaft into place. However, the instructions say to test the reset function after installing the new shaft before reassembling the entire thing. When I hold the mechanism in my hand and push in the reset button all my tripometer goes to all 4s... what the heck does this mean?? How do I make it reset to 0s?

I had to push mine a few times. Eventually it started showing zeros.

Jonathan
08-12-2016, 09:57 AM
I had to push mine a few times. Eventually it started showing zeros.

Same here. Needs to be pushed a few times. It also seems to be affected by how you apply that small force with your finger, meaning, when you push it in, is your finger pushing a little down or a little to the side. I think they are a little finicky. Maybe just mine, maybe all of them (design).

DMCMW Dave
08-12-2016, 09:29 PM
It should reset to all zeros when you push the knob all the way in. Every time. It's hard to describe how to do it, but essentially you have to take the number drum back out and screw around with it, sorry there isn't a more clear way to describe it.

Morpheus
09-20-2016, 10:46 PM
It should reset to all zeros when you push the knob all the way in. Every time. It's hard to describe how to do it, but essentially you have to take the number drum back out and screw around with it, sorry there isn't a more clear way to describe it.

Is the number drum spring loaded? I could have sworn that I heard something unravel a bit when I changed out my reset shaft, and now I have to press several times to reset to all zeros.

DMCMW Dave
09-21-2016, 12:20 AM
Is the number drum spring loaded? I could have sworn that I heard something unravel a bit when I changed out my reset shaft, and now I have to press several times to reset to all zeros.

There are no springs inside the drum.