spikeygg
08-13-2016, 06:05 PM
So I'm putting my console back together finally. Everything is going great, I get to that darn black plate with the dimmer rheostat and clock on it and wouldn't you know it, I can't get it to sit properly. Even without considering the A/C panel. It seems that my mounting holes are too close together to even fit the plate. Take a look at these pictures, they may better explain:
Here's what it looks like when I'm trying to line up the rear holes:
45384
Here's a picture of the shifter mounting holes and the measured distance between them:
45385
Here's a pciture of the clock plate's mounting points with measurements:
45386
What am I doing wrong? I tried to adjust the little metal standoff that the clock plate mounts to but there doesn't seem to be any play in it.
Here's what it looks like when I'm trying to line up the rear holes:
45384
Here's a picture of the shifter mounting holes and the measured distance between them:
45385
Here's a pciture of the clock plate's mounting points with measurements:
45386
What am I doing wrong? I tried to adjust the little metal standoff that the clock plate mounts to but there doesn't seem to be any play in it.