View Full Version : Electrical Engine Bay Light Switch
spikeygg
09-11-2016, 11:45 PM
Hi guys. When I got my car I found that my engine bay light switch was completely missing. I purchased one from DeLorean.com and I just installed it today. Unfortunately, the light never goes off. When I close the lower engine compartment panel it does not depress the switch enough to turn the light off. What are my options here? Anyone have "the perfect fix" for this problem?
:)
David T
09-11-2016, 11:53 PM
Hi guys. When I got my car I found that my engine bay light switch was completely missing. I purchased one from DeLorean.com and I just installed it today. Unfortunately, the light never goes off. When I close the lower engine compartment panel it does not depress the switch enough to turn the light off. What are my options here? Anyone have "the perfect fix" for this problem?
:)
Be careful. That light in the engine bay will melt if it stays on long enough. The brass contacts inside will touch and short out blowing the fuse. Most owners will disconnect one of the wires at the switch so the light won't go on. It is in a bad place and doesn't provide much light in the right spot anyway.
DMCMW Dave
09-11-2016, 11:56 PM
Hi guys. When I got my car I found that my engine bay light switch was completely missing. I purchased one from DeLorean.com and I just installed it today. Unfortunately, the light never goes off. When I close the lower engine compartment panel it does not depress the switch enough to turn the light off. What are my options here? Anyone have "the perfect fix" for this problem?
:)
You are probably missing the little pin that presses it. Cleverly called a "light switch actuator"
http://store.delorean.com/p-9651-lgt-sw-actuator.aspx
Or it's just install out of alignment.
Anything that fills up the space is OK, this is good in a pinch although a lot more expensive:
http://store.delorean.com/p-9393-rstrip-common-end.aspx
Was in the midst of answering a different way.
Am deferring to Dave on this one, thank you.
Our early-VIN D did not have the part he points to, so now I'll be looking to get one of those, too.
spikeygg
09-12-2016, 12:04 AM
Be careful. That light in the engine bay will melt if it stays on long enough. The brass contacts inside will touch and short out blowing the fuse. Most owners will disconnect one of the wires at the switch so the light won't go on. It is in a bad place and doesn't provide much light in the right spot anyway.
No worries there, one of the first things I did was replace it with an LED. Also, since the car is under restoration (door panels out at the moment) the battery is unplugged so all lights are off when I'm not near the car.
You are probably missing the little pin that presses it. Cleverly called a "light switch actuator"
http://store.delorean.com/p-9651-lgt-sw-actuator.aspx
Or it's just install out of alignment.
Anything that fills up the space is OK, this is good in a pinch although a lot more expensive:
http://store.delorean.com/p-9393-rstrip-common-end.aspx
This piece is missing, I didn't even know it existed! Thanks Dave, that's exactly what I was looking for.
-Greg
Silverbullet
09-12-2016, 12:38 AM
I installed a rocker switch, as there is no need for the light most of the time, as I open the engine cover in the day time....
cdrusn
09-12-2016, 01:00 AM
:thumbup2:
Great idea to change out the switch and the light with an LED. Take the switch out (or the glovebox switch if easier) take it to radio shack and see if they have one that is nearly the same size in a rocker.
Chris 16409
09-12-2016, 02:58 AM
I've done the same thing. This should do the trick:
http://www.oreillyauto.com/site/c/detail/CTI0/85915/N0945.oap
46244
SS Spoiler
09-12-2016, 09:11 AM
I mounted two mini spot lights at each conner of
the engine cover....really helps.
Jonathan
09-12-2016, 07:09 PM
Thought this might make for a good addition to the "helpful technical photos" thread, so I took a couple pictures of the clip and switch on my car and added it to the thread here:
http://dmctalk.org/showthread.php?10336-Assorted-helpful-technical-photos&p=205863&viewfull=1#post205863
Ryan King
09-13-2016, 09:02 PM
I've done the same thing. This should do the trick:
http://www.oreillyauto.com/site/c/detail/CTI0/85915/N0945.oap
46244
Yup. Best method.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.