View Full Version : Engine Dwell/RPM meter fried my coil?
Mattglas
09-15-2016, 12:33 AM
Something strange is happening to all my ignition coils, so far I've been through three... My most recent mishap happened when I hooked up my dwell/rpm meter to the positive side of the coil and to ground like some guy on YouTube showed. After starting, the needle on the meter didn't move at all so I shut off the car and disconnected the meter. Now my car won't start and there's no spark. Did I hook up the meter wrong?
The funny this is that this isn't even the first time this has happened, my first stock coil died randomly which I thought was due to old age. Then the "new" coil I ordered from Dmc Texas made it literally ten feet before dying. Is this just bad luck, or are the coils very sensitive? Can I add some sort of protection circuit to protect my future coils?
Unlikely the meter caused this problem.
Sounds like overvoltage to the coil. It needs higher voltage during cranking but not while running or else.....the coil gets fried. Same system as most all cars of that and previous eras.
In other words the DeLorean HAS a 'protection circuit' for the coil but yours probably isn't working well anymore.
See the Compensating Resistor section here:
LINK: http://delorean.wikia.com/wiki/Ignition_system (http://delorean.wikia.com/wiki/Ignition_system)
Bitsyncmaster
09-15-2016, 06:05 AM
Even if your meter was shorting the test leads, that would not have hurt the coil. It would have increased the current in the ignition resistor (stock wiring).
You need to test for voltage on the + side of the coil and trace the wiring back from there if you don't have voltage.
Mattglas
09-15-2016, 07:30 PM
I probed the two coil lines (+ to +, - to -) with a multimeter and found that I got 6-7v in the 2nd key position and 4-5 volts when cracking. Then I tested between the positive side wire and ground. Which resulted in 10.7-11.1v in second position and 9.6v cranking. Is that normal?
Bitsyncmaster
09-15-2016, 07:37 PM
I probed the two coil lines (+ to +, - to -) with a multimeter and found that I got 6-7v in the 2nd key position and 4-5 volts when cracking. Then I tested between the positive side wire and ground. Which resulted in 10.7-11.1v in second position and 9.6v cranking. Is that normal?
Your battery is probably weak. Cranking the battery should stay around 11 volts.
But your coil voltages sound normal. The 4-5 volts when cranking would improve with a good battery.
Jonathan
09-16-2016, 08:57 AM
Matt, do you think you might have just bumped one of the connections while you were working in there? See that everything is still snug on the ballast resistor and the top of the ignition coil.
And make sure your auto shifter is pushed all the way up into PARK. If it isn't, it won't let you start the car either.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.