Jonathan
09-16-2016, 09:33 AM
Just to clarify...
If I wanted to test to see if my bulb is working properly in the instrument cluster, is it as simple as jumpering the low level LGO (light green/orange) wire to the black ground wire at the connector for the fuel sender?
Again, this is the warning light in the cluster telling you the fuel level is low. Wiring harness side of the fuel sender has three wires, LGO appears to be for the warning light, black for ground, and GB (green/black) is for the level gauge needle. As I understand it, the 12v comes from the instrument cluster down to the sender, so that if I jumper from the LGO to ground, it will complete the circuit and light the bulb up. Assuming the key is turned in the ignition to at least accessories that is.
My low level light isn't working and I think all it is is the bulb not being positioned correctly from the last time I was in there changing a bulb. Thought this would be a simple way to find out.
If I wanted to test to see if my bulb is working properly in the instrument cluster, is it as simple as jumpering the low level LGO (light green/orange) wire to the black ground wire at the connector for the fuel sender?
Again, this is the warning light in the cluster telling you the fuel level is low. Wiring harness side of the fuel sender has three wires, LGO appears to be for the warning light, black for ground, and GB (green/black) is for the level gauge needle. As I understand it, the 12v comes from the instrument cluster down to the sender, so that if I jumper from the LGO to ground, it will complete the circuit and light the bulb up. Assuming the key is turned in the ignition to at least accessories that is.
My low level light isn't working and I think all it is is the bulb not being positioned correctly from the last time I was in there changing a bulb. Thought this would be a simple way to find out.