PDA

View Full Version : Electrical Headlight problem



Antileon
09-16-2016, 12:11 PM
Suddenly when I go from high beam to low beam I only get "parking light" ( cant use that for driving ) where low beam was supposed to be. Any takes on that ?
Thanks

DMCVegas
09-16-2016, 12:29 PM
Are you saying that your headlights completely turn off, or that the green indicator on the binnacle, above the tachometer lights up?

http://www.zidz.com/forum/1-1138885442.jpg

DMC5180
09-16-2016, 02:24 PM
Suddenly when I go from high beam to low beam I only get "parking light" ( cant use that for driving ) where low beam was supposed to be. Any takes on that ?
Thanks

Does the green indicator come on? If not, check fuse 14. If that's good, you may have have a faulty Stalk switch assembly or perhaps the dip beam relay has failed. If you what to verify the low beam power circuit, remove the main beam relay and put a jumper jumper in terminal 30 and 87. That should give you low beams. If you want to verify the relay, swap it with the High(main) beam next to it. Also check to see that all the relay socket terminals are sitting high in the socket.


Dennis

Antileon
09-17-2016, 04:03 AM
Are you saying that your headlights completely turn off, or that the green indicator on the binnacle, above the tachometer lights up?

http://www.zidz.com/forum/1-1138885442.jpg

Green light is on and I get parking light when I go down from high beam

Jonathan
09-17-2016, 09:05 AM
What are the headlights up front doing? When you have your high beams on, do you see that all four headlights are shining? Sounds like something in the wiper stalk to me too.

Bitsyncmaster
09-17-2016, 09:57 AM
You may just have both low beams burned out.

David T
09-17-2016, 10:13 AM
You may just have both low beams burned out.


Agreed. Pull one of the headlights and check the low beam filament. Two of the headlights contain BOTH a low beam filament AND a high beam filament. That is why it is possible for only the high beams to work.

DMC5180
09-17-2016, 10:51 AM
What are the headlights up front doing? When you have your high beams on, do you see that all four headlights are shining? Sounds like something in the wiper stalk to me too.

Outer bulbs are dual filament. 4 lights ON just means the ALL HI beam filaments are GOOD. He said, the dip(Lo) beam indicator is ON. This verifies the Stalk switch is GOOD. That means 1 of 2 things. 1. Both LO beam elements are burned out. ( not the first time I've heard of that happening, but is Rare ). 2. A bad connection in the harness connector (inside the washer fluid tank area). The GROUNDS are verified GOOD because the HI beams work. Also a Rare 3rd possibility. Mice chewed through the Lo beam Power wire in the LF harness run area.


Dennis

David T
09-17-2016, 11:11 AM
Not as rare as you may think. One headlight burns out and is not noticed. When the second one burns out you can't help but notice! Anyway the next step is to either check the filament or test for power on the low beams and is best done by removing a headlight. It is more likely blown filaments than a wring problem or a bad switch.