PDA

View Full Version : Engine Idle Control ECU



MJH
09-25-2016, 10:23 AM
Hi
Just trying to set up Idle and CO2 on my car

Fitted new Idle Control Valve and microswitch, Idle seems to still be all over the place, tested control valve that if it was opening and closing, which it is ,and dis connected passenger side plug on ECU

after reading on the forum it should be 2000 but mine shot up to 3500 !!

Does anyone think this could be a mixture problem or ECU?

Any ideas would be good, it's driving me mad!!
Regards mike

Bitsyncmaster
09-25-2016, 12:01 PM
Hi
Just trying to set up Idle and CO2 on my car

Fitted new Idle Control Valve and microswitch, Idle seems to still be all over the place, tested control valve that if it was opening and closing, which it is ,and dis connected passenger side plug on ECU

after reading on the forum it should be 2000 but mine shot up to 3500 !!

Does anyone think this could be a mixture problem or ECU?

Any ideas would be good, it's driving me mad!!
Regards mike

Mine would run at 2500 RPM with the connector disconnected. Yours could be higher if your advance is on or curb idle is set to high.

Try pulling the vacuum hose off the distributor to test if the advance is on.

David T
09-25-2016, 02:29 PM
Mine would run at 2500 RPM with the connector disconnected. Yours could be higher if your advance is on or curb idle is set to high.

Try pulling the vacuum hose off the distributor to test if the advance is on.

The ECU and the idle motor are usually NOT the problem. Vacuum leaks, things out of adjustment, etc are the more common causes of idle speed problems. Make sure you are tripping the idle micro, it is connected and not bad. If the idle micro is not turning on the idle ECU then it an have no effect on the idle.