View Full Version : Suspension Torquing this nut on the tie rod end
1batt4u
09-25-2016, 01:22 PM
This nut has to be torqued against the tie rod end correct?
How much torque, and how do you hold down the tie rod ends when trying to torque that nut??
http://i64.tinypic.com/15hkd4n.jpg
David T
09-25-2016, 01:39 PM
There is no torque spec for that nut. As a practical matter the only way you could torque it would be with a crowfoot on a torque wrench and that would affect the spec depending on the specific size of that crowfoot. There should be flats on the tie rod or you would hold back with a pliers, a pipe wrench or a vise-grip. You could also put a witness mark of paint on it to indicate movement. Since it is a large nut it should be more than snug, it should be very tight. It is bad practice to lock that nut and not hold back, you could damage the tie rod end (aka track rod) if yo allow it to turn against the stud.
1batt4u
09-25-2016, 01:42 PM
So I just turn it by hand against it, does not need to be tightened?
Bitsyncmaster
09-25-2016, 01:48 PM
An open end wrench should fit onto the tie rod and an open end wrench onto the lock nut. Yes you tighten it up normal force to keep the shaft from rotating after you set the toe.
David T
09-25-2016, 01:51 PM
Just because there is no torque spec does NOT mean hand tight. It should be VERY tight.
1batt4u
09-25-2016, 01:57 PM
Ok thank you guys!!
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.