View Full Version : Frame & Body Filler for inner door seal gap?
DMC-81
10-22-2016, 07:36 PM
Hi there,
After I attached my first inner door seal today, there was a small gap between the two halves. The picture shows the area before fastening. (I used 3M super weatherstrip adhesive to fasten the little piece inside the rubber bulb.)
What is the best thing you guys used to fill in the gap? Is there such a thing as a rubber putty? The original seal was filled in so that it was inconspicuous.
46834
Thanks.
DMCMW Dave
10-22-2016, 11:43 PM
Hi there,
After I attached my first inner door seal today, there was a small gap between the two halves. T.
There shouldn't be a gap, the two ends should touch and be glued together. Did you cut it too short or did it come that way? If it came that way, call the vendor who sold it to you and get it replaced.
DMC-81
10-23-2016, 03:45 PM
There shouldn't be a gap, the two ends should touch and be glued together. Did you cut it too short or did it come that way? If it came that way, call the vendor who sold it to you and get it replaced.
Hi Dave,
No, I didn't cut it too short. Sorry, I guess a better word for gap is "seam". The kit is DMC, and here are the 2 sides after I cut and fitted them:
Driver's side:
46842
Passenger side:
46841
Here is the seam on the OEM seal. It has a strong filler that makes it hard to see the seam:
46843
What do I use for glue? The same 3M Super Weatherstrip Adhesive that I used for the outer seal, or something else?
Thanks.
cdrusn
10-23-2016, 06:32 PM
ultra black gasket maker in between ends then use a razor blade to smooth it when in place. Use the weatherstrip adhesive on the door frame to hold it on. :race:
SS Spoiler
10-23-2016, 07:13 PM
Iv'e seen a small rubber tube slipped inside
the hollow part to keep it even....
DMCMW Dave
10-23-2016, 09:04 PM
In that case, all you need is black 3M Weatherstrip Adhesive.
DMC-81
10-23-2016, 09:33 PM
OK, thanks everyone!
David T
10-23-2016, 10:09 PM
OK, thanks everyone!
If it is a little on the short side you can pull and stretch it a little so you have a tight fitting seam. From the picture it looks like the ends are a little ragged, they should be cut straight. You use the short piece of hose to keep the seal from collapsing at the joint and as mentioned the 3M black adhesive is OK just use it sparingly, it is VERY messy stuff to work with.
DMCMW Dave
10-24-2016, 12:35 AM
it is VERY messy stuff to work with.
If you don't want to get messy, quit working on cars and take up carpentry.
sdg3205
10-24-2016, 03:15 AM
... quit working on cars and take up carpentry.
... but the dust, Dave... the dust.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.