spikeygg
11-13-2016, 03:28 PM
Today I decided to remove the seats.
Since I got the car in June the rails were very difficult to adjust so I knew taking the seats out would be a can of worms. While I was removing them I learned that someone had previously removed the driver's seat and replaced both studs on one side with standard hardware. This was terrible because it made removing the nuts on the bottom very difficult.
Crappy standard hardware:
47304
Anyway, when I finally got the driver's side seat out I found a rather large hole in the floor board. It's in the fiberglass, how do I properly patch this one?
Under the driver's seat:
47307
The hole from the top:
47306
The hole from the bottom:
47305
Secondarily, I've pulled the rails from both seats and I need to pull them apart so I can replace the sliding parts. Anyone have experience taking these apart? They have a spring so I'm a little weary of disassembly without understanding how to proceed...
Under seat rail system:
47309
Spring on one side of the rail system:
47308
Thanks,
-Greg
Since I got the car in June the rails were very difficult to adjust so I knew taking the seats out would be a can of worms. While I was removing them I learned that someone had previously removed the driver's seat and replaced both studs on one side with standard hardware. This was terrible because it made removing the nuts on the bottom very difficult.
Crappy standard hardware:
47304
Anyway, when I finally got the driver's side seat out I found a rather large hole in the floor board. It's in the fiberglass, how do I properly patch this one?
Under the driver's seat:
47307
The hole from the top:
47306
The hole from the bottom:
47305
Secondarily, I've pulled the rails from both seats and I need to pull them apart so I can replace the sliding parts. Anyone have experience taking these apart? They have a spring so I'm a little weary of disassembly without understanding how to proceed...
Under seat rail system:
47309
Spring on one side of the rail system:
47308
Thanks,
-Greg