View Full Version : Electrical Power Windows
Cummil2
08-05-2017, 01:36 PM
Looking for some help , Both electric windows don't work , Checked fuses replaced the switches , no noise when I press the switches , relay or motor noise , just silence and no movement
Jonathan
08-05-2017, 01:46 PM
Take the upper trim piece off the inside of each door and have a look if you haven't already. Might be something pretty obvious once you look to tell you which direction to take your troubleshooting.
Ratrace427
08-05-2017, 02:48 PM
Hook each motor direct to a battery. Make a jumper and start with the passenger side. It's close to the battery. Doesn't matter the polarity. Polarity changes the direction of movement
Sent from my SM-G920R4 using Tapatalk
Ratrace427
08-05-2017, 02:51 PM
Most likely stuck. The mechanism will rust inside the tube. Factory ones are really noisy anyways. Like really noisy
Sent from my SM-G920R4 using Tapatalk
Use a 12V test lamp or a voltmeter to see if you really have 12V(+) into both new switches. With a new fuse and with ignition in ACC or ON position you should have 12V at the switch.
Just as importantly, check that this circuit is properly grounded. Test that at the switches, too (BLK wire). They are both grounded to the same point.
Cummil2
08-06-2017, 06:57 AM
Use a 12V test lamp or a voltmeter to see if you really have 12V(+) into both new switches. With a new fuse and with ignition in ACC or ON position you should have 12V at the switch.
Just as importantly, check that this circuit is properly grounded. Test that at the switches, too (BLK wire). They are both grounded to the same point.
It is the actual switch connectors in the console, hard cracked and touching , will source new ones , thank you
Cummil2
08-06-2017, 08:55 AM
It is the actual switch connectors in the console, hard cracked and touching , will source new ones , thank you
Trying to remove the window actuator , did I separate the motor from the housing to remove , have tried everything but unable to take it out ?
Lwanmtr
08-10-2017, 06:22 AM
You have to make sure to unscrew the actuator from the drop glass also.
Other than that, it is fiddly to get them out...just be patient....getting new ones back in is fiddly too...but if you go slowly, you can get it.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.