DMCH Fuel pump float ordination question

[Dontilgon]

Just getting around to installing but can’t find a pic of which way the float goes on.Its not in the instructions that was provided . Thanks

[WHO1DMC]

Just getting around to installing but can’t find a pic of which way the float goes on.Its not in the instructions that was provided . Thanks

The 1st pic where it goes off to the side is how I put mine. It will occupy the same space as the original fuel sender.
Also there is a few YouTube videos of these being put in that my help.

Dave B.

[Bitsyncmaster]

The float would have to stay floating on the surface of the gas in the tank. What your photos show does not look correct since the float would tilt at an angle in the gas. The arm on the resistor must have another way to install it.

[dmcnc]

https://uploads.tapatalk-cdn.com/20190915/50121711307e42c80efe02fd0ecb9e62.jpg
The bent end goes into the rotary arm.

https://uploads.tapatalk-cdn.com/20190915/dfe6f76bfd2138635b5b9c8974e30d09.jpg

In line with the sender arrow- all the way until the clips engage
https://uploads.tapatalk-cdn.com/20190915/bd918c9b65f993c80f7cfa3aa76f7da4.jpg

[Dontilgon]

Damn didn’t think of that one THANKS!!!

[WHO1DMC]

Was in a rush didn't notice the peg wasn't in the hole.

Whoops
Dave B.