Jeffhucik
01-14-2020, 02:44 PM
I’ve decided to do a Motor swap in my car. I am going to have an original full clean motor (including stock exhaust) and matching 5 speed manual trans with only 21k miles out of an Oct of 81’ car.
Only thing is I’m not sure what it’s worth. Ive gotten some info from delorean go that I could snag around 3-4K for the engine and maybe 1-2k for the trans. Does this sound right?
Motor has had the following maintenance performed in the last 4 years with records to go with all upgrades.
ENGINE:
Water pump, alternator, starter, cold start & fuel injector cleaning. Fuel distributor & warm up regulator replacement. Vacuum line kit, fuel regulator shimmed, Rear Main Engine Seal. Major tune up kit installed (plugs, wires, ignition distributor, valve cover gaskets). Intake manifold was removed, valley cleaned, Y-pipe in valley was removed, cleaned w/New Gaskets. valley coolant tube run replaced, and intake / throttle gaskets replaced on reinstall. Recently purchased NOS lambda probe. Everything with new hardware on replacement.
McKeen microcontrolled idle Ecu and Solid State RPM Relay would be included
TRANS:
clutch & axle seals have been replaced.
Extras: I’d included a dwell meter and an exhaust gas analyzer as well for tuning the air fuel ratio.
Any help would be greatly appreciated. I don’t even know where to post it for sale.. here??
Only thing is I’m not sure what it’s worth. Ive gotten some info from delorean go that I could snag around 3-4K for the engine and maybe 1-2k for the trans. Does this sound right?
Motor has had the following maintenance performed in the last 4 years with records to go with all upgrades.
ENGINE:
Water pump, alternator, starter, cold start & fuel injector cleaning. Fuel distributor & warm up regulator replacement. Vacuum line kit, fuel regulator shimmed, Rear Main Engine Seal. Major tune up kit installed (plugs, wires, ignition distributor, valve cover gaskets). Intake manifold was removed, valley cleaned, Y-pipe in valley was removed, cleaned w/New Gaskets. valley coolant tube run replaced, and intake / throttle gaskets replaced on reinstall. Recently purchased NOS lambda probe. Everything with new hardware on replacement.
McKeen microcontrolled idle Ecu and Solid State RPM Relay would be included
TRANS:
clutch & axle seals have been replaced.
Extras: I’d included a dwell meter and an exhaust gas analyzer as well for tuning the air fuel ratio.
Any help would be greatly appreciated. I don’t even know where to post it for sale.. here??