dmcman73
07-03-2020, 06:46 PM
I a just getting around to reassembling my intake manifold and I had asked another Delorean owner where a bindle of grand wires went that came off of the look with the WUR and Cold Start valve connectors came out. When I received the picture, it showed the ground bundle was attached to the top of the air intake on the drivers side. In his picture, I did not see the top portion of the Idle Speed motor support like on mine (see picture), but that's where the grounds are attached in his picture. I did a search on different Delorean engines and every picture I saw, it was the same as the other Delorean owners image, no top portion of the bracket attached to the threaded hole, just the ground wires.
1. Do I have a different bracket than everyone? I looked on DMCH parts page and it shows the same bracket as mine and it installing the same way.
2. I assume that the ground wires get attached to that same bolt that the bracket attached to and that the lug goes under the bracket?
My engine, notice that the top portion of the idle speed motor support is mounted to
63992
Here is an image capture from a Youtube video I was watching, the Idle speed support bracket is different and just the ground wires are bolted to the intake, this matches the same picture the other Delorean owner sent me.
63993
1. Do I have a different bracket than everyone? I looked on DMCH parts page and it shows the same bracket as mine and it installing the same way.
2. I assume that the ground wires get attached to that same bolt that the bracket attached to and that the lug goes under the bracket?
My engine, notice that the top portion of the idle speed motor support is mounted to
63992
Here is an image capture from a Youtube video I was watching, the Idle speed support bracket is different and just the ground wires are bolted to the intake, this matches the same picture the other Delorean owner sent me.
63993