Knee pad studs

[tgraham]

Does anyone have a source for these? This is the step stud that is used on the knee pads... apparently I took them off years ago and have not found the box. Now I can’t seem to find replacements! They seem to be M10-1.5 to M6-1.0... a rather odd combo.

Thanks!
Travis

65531

[DMC5180]

Does anyone have a source for these? This is the step stud that is used on the knee pads... apparently I took them off years ago and have not found the box. Now I can’t seem to find replacements! They seem to be M10-1.5 to M6-1.0... a rather odd combo.

Thanks!
Travis

65531

Just so you know it’s not one stud. the M6 is threaded into the M10 threaded insert. You can get these type of inserts at a good hardware store. The might not have metric but you should be able to make something work.

https://www.ebay.com/itm/M6-M10-Threaded-Insert-Nuts-For-Furniture-Connection-Allen-Blind-Hole-Straight-/154148797338?_trksid=p2349624.m46890.l49292

[tgraham]

Hey Dennis,

Thanks! I didn't actually know that :) That'll make it easier. I guess I either didn't investigate enough and/or mine are crusty enough not to notice. You learn something new every day.

Travis

[jackb]

You can cut a piece of threaded rod snd use epoxy/jbweld putty/similar to put it in place to make your own.

[MrChocky]

While you're at it, consider using wing nuts for future access.