T-Panel screw sizes?

[Parzval]

I've had my T-panel off the car so long I've misplaced the screws, including the ones that hold the slotted fiberglass trim that retains the back edge. I had #8 sheet metal handy because I had to replace the ones in the front edge bracket. But the #8 seems too small for the panel itself (although they do grab). And it seems like the rear trim might be #8, but perhaps machine screw not sheet metal. The sheet metal ones caught, but didn't thread and I didn't want to force them.

TIA
Josh

[DMCMW Dave]

I've had my T-panel off the car so long I've misplaced the screws, including the ones that hold the slotted fiberglass trim that retains the back edge. I had #8 sheet metal handy because I had to replace the ones in the front edge bracket. But the #8 seems too small for the panel itself (although they do grab). And it seems like the rear trim might be #8, but perhaps machine screw not sheet metal. The sheet metal ones caught, but didn't thread and I didn't want to force them.

TIA
Josh

They are a metric sheet metal screw. N8. Either order from a vendor or use something close. #8 too small, #10 too big. Good like finding metric sheet metal screws at Ace Hardware :mecry:

The plastic panel is held on by metric machine screws. M4

[Parzval]

They are a metric sheet metal screw. N8. Either order from a vendor or use something close. #8 too small, #10 too big. Good like finding metric sheet metal screws at Ace Hardware :mecry:

The plastic panel is held on by metric machine screws. M4

Thanks a lot!
👍