Rear fascia fitment/warping

[Timeless]

Left side of the rear fascia is bowed out - right side is ok. Anyone has this issue with their car? Perhaps heat gun to assist in manipulation?
6954869549

[ssdelorean]

Left side of the rear fascia is bowed out - right side is ok. Anyone has this issue with their car? Perhaps heat gun to assist in manipulation?
6954869549

It's that FL sun! You need to move back to MI! ;-)

[Timeless]

It's that FL sun! You need to move back to MI! ;-)
HA! It's been like that since I acquired it - was in a garage in OK/TX for 20 years. The front fascia is great and minimal eyebrows when I got it which have been remedied.

[painterdave72]

you can take the light out and loosen the three nuts that hold the side of it tight and try to move it in a bit. but yeah a heat gun carefully will help also...

[Timeless]

Heat gun treatment did not provide much, if any, help at all. While the tail lights are out for polishing I'll be replacing all 6 mounting nuts and washers.

[Ron]

A lot to remove in order to get to it, but you might try changing the quarter panel's arc by bending its bracket (https://store.delorean.com/catalogsearch/result/?q=110053). Worked for us.

[Timeless]

Fixed. Missing hardware was the culprit. Replaced all 6 nuts with new SS pieces - gaps have been closed.