PDA

View Full Version : Door lock module upgrade to control actuartors


hjhjr
07-10-2023, 01:57 PM
69847698486984969850698516985269853698546985569856
hjhjr
07-18-2023, 05:39 PM
enlarged schematic diagram 6987069869
hjhjr
07-20-2023, 07:06 PM
No one has replied to my thread. good, bad , indifferent
Bitsyncmaster
07-20-2023, 08:01 PM
Good work. Yes it works to have the relays ground the unused side so it can work with actuators or solenoids. You may want to replace the stock ground wire in the harness which is about 19 AWG to a 16 AWG. But it does work with my actuators without that wire improvement.
hjhjr
07-21-2023, 12:43 AM
In all my Delorean internet browsing, I never ran into this modification. I intended for it to work with actuators only.
hjhjr
08-20-2023, 06:12 PM
This modification only uses the two 12volt wires that went to the solenoids. No ground needed only polarity reversing.