bitMuse
01-04-2024, 07:50 AM
I had the engine bay of my electric conversion scanned for help in planning certain aspects of my build, and I am sharing it here as a resource for others.
Important callouts: My rear strut towers, crossbeam are custom fabricated, and the engine is obviously different. So don't base your measurements off of those.
However everything else about the bay is the same, and it's likely you could use this to see if various engines would fit.
External Link to File HERE (https://www.dropbox.com/scl/fi/2r0dl7wkkfqzmc43uccmc/Engine-Bay-Reduced-Resolution-mm.stl?rlkey=3tijbh74mqe2b7lmabi1jtlnu&dl=0)
The units are in the only correct unit ... mm. Invitations to fight about this welcome in the back of local denny's parking lot. :P
Important callouts: My rear strut towers, crossbeam are custom fabricated, and the engine is obviously different. So don't base your measurements off of those.
However everything else about the bay is the same, and it's likely you could use this to see if various engines would fit.
External Link to File HERE (https://www.dropbox.com/scl/fi/2r0dl7wkkfqzmc43uccmc/Engine-Bay-Reduced-Resolution-mm.stl?rlkey=3tijbh74mqe2b7lmabi1jtlnu&dl=0)
The units are in the only correct unit ... mm. Invitations to fight about this welcome in the back of local denny's parking lot. :P