Mark D
11-28-2011, 01:45 PM
Can someone please verify the torque spec for the two large nuts on the end of the transmission shafts? I'm referring to the ones that typically tend to back off the shafts and punch a hole in the trans end casing.
The shop manual says 90-112.5 ft-lbs but I coulda sworn from the previous .com discussion that it should be around 120 or something higher than what is listed.
Also, what size socket(s) will I need to re-torque the nuts? They look like they're both the same size but they have different part numbers for each.
The shop manual says 90-112.5 ft-lbs but I coulda sworn from the previous .com discussion that it should be around 120 or something higher than what is listed.
Also, what size socket(s) will I need to re-torque the nuts? They look like they're both the same size but they have different part numbers for each.