Therm Vac Switch vacuum line routing?

[rundmc]

Although I tagged these three vacuum lines carefully on the Therm Vac switch that inserts into the Y-Pipe, I am assuming nothing as I go back over my vehicle looking for the source of my starting issue. Can anyone here tell me where each of these lines goes. On my switch, the barbs are labeled 1, 2 and D. The photo below is before cleaning and reassembly was complete and shows the tagged lines.

Thanks

http://3.bp.blogspot.com/-ZavdI3O8648/T2fqFiv9x4I/AAAAAAAAAkk/gCqO3BJy7U0/s1600/IMG_1848.JPG

[Delorean Industries]

There is a vacuum diagram on your lower engine cover that shows the correct routing. This should also be in the resource section of this forum.

[rundmc]

I keep forgetting that because my engine cover isn't on my vehicle at the moment. thanks

[1batt4u]

Here are 3 pictures I attached to help where everything goes!

[rundmc]

Thanks!