View Full Version : Engine nead advice on my crankshaft seal
krustydmc
05-06-2012, 10:57 AM
Hi im installing a new dmc crankshaft seal
The new seal is not the same depth
as the old one. Should I mounth n
Flush to the outside or push it
Down.
82DMC12
05-06-2012, 01:36 PM
Where did you get the crank seal? Mount it flush. I replaced mine twice because I messed it up the first time!
DMCMW Dave
05-06-2012, 02:16 PM
It's not critical as long as it is in the hole square. If you have a groove worn in the pulley, either sleeve the pulley, or make a measurement and set the seal so that it misses the groove.
Just don't push it out the back. That will ruin your day. There is no back stop.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.