PDA

View Full Version : Somebody who works on clutches/front tires, I NEED HELP.



xjoshsmallx
05-06-2012, 12:07 PM
I have a '96 Toyota Camry 5-speed, 4 cyl, my mom let her room mate barrow the car some months ago and she seemed to have run up on something under the car pretty good because the bottom panel that protects against mud and what not was broken in half....

Here's my problem,
Every time I reverse, I hear this scratching/sliding noise coming from with in the passenger front tire area. This almost never fails for the sound.
While I am driving and immediately let off the clutch and push the gas (pretty bad only through first and second), you'll hear this noise again.
When I am driving and in gear but, let off the gas and coast, at times you'll hear this scratching/sliding noise till when I push on the gas again, then it'll go away.
It's pretty bad when I turn corners as well.
It's been doing this for some months now, we've changed the break pads and what not with-in this time and put new tires on the car. It hasn't exactly effected the driving ability but, my friends did tell me last night they seen sparks come from that area when they were following me.

Does anyone just from reading this have any idea as to what it could be and how to fix it? I have a very important trip to Atlanta the 11th and won't be allowed to use the car unless it's fixed.
Thank you, hope all is well.

outatym2001
05-06-2012, 03:07 PM
xjoshsmallx,

I’m not an auto mechanic but here goes.
You mention, “the bottom panel that protects against mud and what not was broken in half….”

Is the part that is missing also in the exact same area where the noise is?

My guess is you need a brand new half shaft (drive line) that has one universal joint on each end.
Your Camry is front wheel drive so your engine, transmission and half shaft are all up in the front.
There should be some rubber boots protecting the universal joints that should be visible from under the front end.
Maybe a rubber boot was torn open and now all the grease has left the u-joint. Seems to me what ever was hit with the Camry was big enough to do some damage to the half shaft and well that’s all I can think of.
Also, if the noise is even harsher when accelerating in a sharp corner it’s gotta mean the u-joints on one side or the other are severely worn and need replacing.

This would have been a good one to call into the radio show Car Talk.
I listen to them every Saturday morning at 9 am Pacific Time on my local station 94.9 FM. The show is only one hour long.
You can listen to last Saturday’s show for free here. Click on, Listen to full show.

http://www.cartalk.com/

Josh, I found this online.
Toyota Camry Reliability

Coolant leak (1992-96): Head-gasket failure on 3.0-liter engines allows coolant to enter the cylinders.
Hard starting (1992-96): A "cold soak" (prolonged interval between starts) may cause hard starting, due to ignition-coil voltage leaking to an inappropriate ground.
Trunklid (1992-96): The trunklid may not stay fully open on sedans with a spoiler; adjusting the support torsion rod should cure the problem.

Toyota Camry Safety Recalls
1994-96: Insufficiently tightened steering-wheel nut may cause steering vibration and looseness; nut could eventually come off, causing steering wheel to separate from shaft.
1996: The plastic holders for taillight bulbs on some cars can deform due to heat from the bulb.

http://auto.howstuffworks.com/toyota-camry3.htm

DMCMW Dave
05-06-2012, 03:13 PM
I suspect a broken engine mount or two.

xjoshsmallx
05-06-2012, 09:55 PM
I suspect a broken engine mount or two.

This guy right here.

After having another look, I did realize the engine was leaning and in fact, it was a mount or two.


Thank you to the other guy for taking time out of your day to help try and find what could have been wrong.
Hope all is well.