Log in

View Full Version : DeLorean body/spec question.



xjoshsmallx
05-17-2012, 10:30 PM
I know the Proto-1 was a bit wider than the actual production car but, I have a different question.

Were there different casting molds/specs for different years?
I've noticed it in person and even seen it in a pic just now but, some look to be more roundish, and more narrow while others seem to have a very fine edge and look extremely sleek/wide and "Coutach" angled (sharp angled).

I've noticed it in the facia and headlights as well. DMC fl's company picture with the three DeLorean's (one being the Proto-1) you can notice it.

dmc6960
05-18-2012, 12:00 AM
The generalized answer to your question is no.

The detailed answer to your question is yes, barely. There was more than one mold used for the underbodies throughout production, and there are SUBTLE differences between them. The most apparent change was on the early cars which had a textured surface on the pontoons in the engine bay. This became smooth not too far into production.

There were no changes which would alter the appearance of the body. The most visual change you may be seeing in pictures of the exterior is lowered and non-lowered cars.